Maintenance methods and operating procedures for mechanical shearing machine

A mechanical shearing machine is a kind of shearing machine. The mechanical shearing machine adopts a resistance key form of clutch structure and open gear transmission and adopts more advanced electrical appliances (footswitch, manual switch) for operation, low noise, easy operation, and maintenance. Next, let's take a look at the maintenance methods and operating procedures of the mechanical shearing machine. Here are some answers.

Here is the content list:

• Maintenance method of mechanical shearing machine.

• Operating procedures for mechanical shearing machine.

Maintenance method of mechanical shearing machine.

First, operate in strict accordance with the operating procedures. Second, the mechanical shearing machine should be lubricated according to the lubrication chart at a fixed time, fixed point, and quantitatively before starting each time. The oil ought to be clean and free from precipitation. Third, the machine tool must always be kept clean, and the unpainted parts must be anti-rust grease. Fourth, the lubricating oil in the motor bearing should be regularly replaced and refilled, and the electrical part should be regularly checked for normal, safe, and reliable operation.

Fifth, regularly check whether the V-belts, handles, knobs, and buttons are damaged. If they're severely worn, they ought to get replaced in time, and therefore the spare components ought to be rumored for replacement. Sixth, check and repair switches, insurances, and handles regularly to ensure reliable operation. Seventh, lubricate and scrub the machine tool 10 minutes before getting off work every day. Eighth, it is strictly forbidden to operate the mechanical shearing machine by non-designated personnel, and usually must be stopped by people.

Operating procedures for mechanical shearing machine.

First, it is forbidden to use the shearing machine with overload, and not to cut quenched steel, high carbon steel, alloy tool steel, cast iron, and brittle materials. Second, check the mechanical shearing machine by the instructions and prepare for driving. The motor is not allowed to start with load, and the clutch should be disengaged before driving. Third, turn the pulley by hand before driving a few times, observe whether the blade movement is obstructed, and then drive the empty car to check that it is normal to start cutting, and it is forbidden to start it suddenly. Fourth, always check whether the tie rod is out of order and whether the screws are loose.

Fifth, pay attention to the safety of your fingers when feeding materials. Don't place your fingers beneath the sheet to feed the fabric or feed your fingers into the leading edge. It is strictly forbidden for multiple people to operate a mechanical shearing machine at the same time. It is strictly for one person, one machine, and no standing behind the machine. The person receives the material. Sixth, the blade must be sharp. The blade should be shut once cutting skinny plates. The upper and lower blades must be parallel. The gap between the blades must not be greater than one-third of the sheet. Seventh, the machine must be stopped before adjusting or cleaning. Eighth, after setting the knife, you need to do the hand-trigger experiment and empty-car inspection. Ninth, no other items should be placed on the workbench of the mechanical shearing machine.

Our official website is https:// www.zczgmachine.com/. If you buy a mechanical shearing machine, you can communicate with us on the website.